Search results for "phosphotungstic acid"
showing 10 items of 15 documents
Effect of TiO2 and Al2O3 Addition on the Performance of Chitosan/Phosphotungstic Composite Membranes for Direct Methanol Fuel Cells
2023
Composite chitosan/phosphotungstic acid (CS/PTA) with the addition of TiO2 and Al2O3 particles were synthesized to be used as proton exchange membranes in direct methanol fuel cells (DMFCs). The influence of fillers was assessed through X-ray diffraction, scanning electron microscopy, thermogravimetric analysis, liquid uptake, ion exchange capacity and methanol permeability measurements. The addition of TiO2 particles into proton exchange membranes led to an increase in crystallinity and a decrease in liquid uptake and methanol permeability with respect to pristine CS/PTA membranes, whilst the effect of the introduction of Al2O3 particles on the characteristics of membranes is almost the op…
Fuel Cell Performances of Bio-Membranes Made of Chitosan-Polyelectrolyte Thin Films and Nanowires into Anodic Alumina Membranes
2012
Chitosan (CS) / Phosphotungstic acid (PTA) polyelectrolytes in the shape of thin films and nanowires supported by Anodic Alumina Membranes (AAM) have been fabricated through solution cast and filtration techniques, respectively. Their ability to function in a H2/O2 fuel cell under mild conditions (room temperature, low humidity and low Pt loading) is proved for the first time. The fabricated membrane electrode assemblies produce power peaks of ~20 mW cm-2 for both films and nanowires. The CS/PTA films (20-40 μm thick) are able to produce a quite constant power density of ~10 mW cm-2 recorded for at least 7 h. The gradual decrease of the power output with time observed for CS/PTA nanowires i…
Influence of synthesis conditions on the performance of chitosan–Heteropolyacid complexes as membranes for low temperature H2–O2 fuel cell
2015
Flat, free-standing chitosan/phosphotungstic acid (PTA) polyelectrolyte membranes were prepared by in-situ ionotropic gelation process at room temperature on porous alumina support firstly impregnated by H3PW12O40. Scanning electron microscopy revealed the formation of compact and homogeneous membranes, whose thickness resulted to be dependent on chitosan concentration and reticulation time. X-ray diffraction and Fourier transform infrared spectroscopy (FTIR) evidenced the formation of almost amorphous membrane without appreciable concentration of not protonated NH2 groups and PTA3- ions with preserved Keggin structure. Membranes were tested as proton conductor in low temperature H2-O2 fuel…
Chitosan-phosphotungstic acid complex as membranes for low temperature H2-O2 fuel cell
2015
Abstract Free-standing Chitosan/phosphotungstic acid polyelectrolyte membranes were prepared by an easy and fast in-situ ionotropic gelation process performed at room temperature. Scanning electron microscopy was employed to study their morphological features and their thickness as a function of the chitosan concentration. The membrane was tested as proton conductor in low temperature H 2 –O 2 fuel cell allowing to get peak power densities up to 350 mW cm −2 . Electrochemical impedance measurements allowed to estimate a polyelectrolyte conductivity of 18 mS cm −1 .
Differential staining of mucin granules from epoxy resin sections by a phosphotungstic acid-methyl green procedure.
1991
After treatment of epoxy resin semithin sections from glutaraldehyde fixed rat large intestine with 5% aqueous phosphotungstic acid (PTA), staining with unpurified 0.2% solutions of methyl green at 60 C for 5 min produces a color differentiation between mucin granules of goblet cells. Some mucin granules and the glycocalyx appear deep green while the remaining granules, luminal mucin and collagen fibers are pink. The known contamination of unpurified methyl green with crystal violet seems to be responsible for the pink staining reaction of the latter structures, which also present an orange-red fluorescence under green exciting light. Electron microscopic observations show selective contras…
Co-crystallization of Keggin type polyoxometalates [HL]3[PW12O40] and [Ln(DMF)8][PW12O40] (Ln=La, Dy, Yb) (L=N-(2-hydroxyphenyl)-3-methoxy-salicylide…
2016
Abstract Four new Keggin type polyoxometalate clusters [HL]3[PW12O40]·5MeOH (1) and [Ln(DMF)8][PW12O40] {Ln = La (2), Dy (3), Yb (4)} (L = N-(2-hydroxyphenyl)-3-methoxy-salicylideneamine) have been synthesized. Co-crystallization of complex 1 with each of the three complexes 2–4 takes place when the Schiff base ligand is treated with hydrated phosphotungstic acid, H3[PW12O40]·xH2O, hydrated lanthanide nitrate, Ln(NO3)3·6H2O in the presence of Ni(NO3)2·6H2O. The Schiff base ligand is protonated in complex 1 and thus it is neutralizing the charge of the polyoxotungstate anion, [PW12O40]3−. A dimethylformamide (DMF) coordinated trivalent lanthanide ion balances the negative charge of the polyo…
Improvement in the performance of low temperature H2-O2 fuel cell with chitosanephosphotungstic acid composite membranes
2016
Abstract Free-standing chitosan/phosphotungstic acid polyelectrolyte membranes, prepared by ionotropic gelation on alumina porous supports, were employed as proton conductor in low temperature H 2 –O 2 fuel cell. A drying step on glass substrate was introduced in the fabrication procedure to reduce shrinkage and consequent corrugation. Membranes were tested with electrodes prepared according to different procedures and with two different Pt loadings, namely 0.5 and 1 mg cm −2 . Both the investigated kinds of electrodes allowed to get very promising power peaks of 550 mW cm −2 in spite of the different Pt content. The polarization curves and the electrochemical impedance spectra suggest that…
Phosphomolybdic acid and mixed phosphotungstic/phosphomolybdic acid chitosan membranes as polymer electrolyte for H2/O2 fuel cells
2017
Abstract Flat, free-standing phosphomolybdic acid and mixed phosphotungstic/phosphomolybdic acid chitosan membranes were prepared by in-situ ionotropic gelation process at room temperature on porous alumina support firstly impregnated by heteropolyacid. Scanning electron microscopy revealed the formation of compact and homogenous polymeric membranes, whose thickness resulted to be dependent on reticulation time, and almost independent on the employed heteropolyacid nature and concentration. X-ray diffraction and Fourier transform infrared spectroscopy evidenced the formation of crystalline membranes without appreciable concentration of unprotonated NH 2 groups and heteropolyacid ions with p…
Nanoscale membrane electrode assemblies based on porous anodic alumina for hydrogen–oxygen fuel cell
2007
In this paper, we demonstrate that nanoscale membrane electrode assemblies, functioning in a H 2/O 2 fuel cell, can be fabricated by impregnation of anodic alumina porous membranes with Nafion® and phosphotungstic acid. Porous anodic alumina is potentially a promising material for thin-film micro power sources because of its ability to be manipulated in micro-machining operations. Alumina membranes (Whatman, 50 μm thick, and pore diameters of 200 nm) impregnated with the proton conductor were characterized by means of scanning electron microscopy, X-ray diffraction, and thermal analysis. The electrochemical characterization of the membrane electrode assemblies was carried out by recording t…
A Deep Insight into Different Acidic Additives as Doping Agents for Enhancing Proton Conductivity on Polybenzimidazole Membranes
2020
[EN] The use of phosphoric acid doped polybenzimidazole (PBI) membranes for fuel cell applications has been extensively studied in the past decades. In this article, we present a systematic study of the physicochemical properties and proton conductivity of PBI membranes doped with the commonly used phosphoric acid at different concentrations (0.1, 1, and 14 M), and with other alternative acids such as phytic acid (0.075 M) and phosphotungstic acid (HPW, 0.1 M). The use of these three acids was reflected in the formation of channels in the polymeric network as observed by cross-section SEM images. The acid doping enhanced proton conductivity of PBI membranes and, after doping, these conducti…